Also made this dude for the driver's side grommet hole where the front wiring harness will pass through. It's painted black now like the one for the other side just no picture, I think you get the idea though. It's for a Molex XRC connector set. Has the anti rotation jam built in. The hole was achieved with a printed paper template, a drill bit, and a die grinder. It's just aluminium so it took like 5 minutes to make. Bolts up to holes I put in the chassis already like the other side.
You can find those at
www.waytekwire.com and lots of other websites. The hole is cut for the 31 position connector. Which is more than adequate for the little amount of stuff I'm using.
Scraped all the chaulking from the engine bay. I can't stand how it looks. I know I'm wierd and my car will probably rust in half because of it, whatever.
The interior is a train wreck right now. So much stuff to change, build, fix. New gauge cluster, new electrics for the whole chassis, cleaning, etc. At some point a roll cage has to get in here. So I'll have to notch the dash for that as well. I'm not sure what will come first. Still trying to figure out who's going to build what on this thing. Pretty much everything in that picture goes in the trash lol.
