It rolls on! Have got so far that I could push the cage down from the boxes and start welding.
We have a total chaos in the garage right now, it use to be pretty crowded, but now it's extremely ...
We've only 100m2 to share
Started with one side, it took a terrible time because I was terrified to grind too much every time. Think I lift up that pipe in place hundreds of times.
Pipe number two took 10minuter
Suspect everyone is doing like this, but I simply took two paper and rolled around the ends of the finished tube. Templated by, measured the distance between the papers on the tube, and made sure the seams were aligned with each other.
Then I took off the paper, and turned inside out on the next tube. Mirror: D
Again, it was I who was a coward, leaving a few millimeters on the first try, but then I put on like a glove!
Here is a view through the speaker hole. The passenger side rear view.
Welding!
It was at the famous, that it was possible to bring down the cage when it is so tight everywhere.
Had to break away mounts to the dashboard.
