[JustJeff]

Here's what I've got so far:

Haven't been able to accurately test my old spark plugs. Batteries in the DMM were low. It tested the new plugs just fine. All 4 9's tested at 4.83-4.91. But the old plugs I had all kinds of trouble getting readings. I was pulling old plugs and testing as I went. Wasn't getting good readings. Some of them the DMM was bouncing all over the place. Literally anything from "OL" to 35.00ish. I got frustrated with it, marked all the plugs for their position in the engine and came back to it later. While trying to test them again the DMM batteries died. I've got some batteries charging overnight and I'll test more tonight once I get home.

I moved the car to the location where I'm gonna pull the engine and looked some things over and generally tinkered around. I played around with my MBC settings to find out more about the stuttering when boost pressure builds. It always happens right when the engine goes from vacuum to boost. If I turn MBC all the way down and purging as much as possible stuttering happens less. What I found is that if I get the engine past that transition from vacuum to boost it boosts just fine once it gets beyond that point. If I turn the MBC up and get on the engine some pressure moves past that zero transition point quickly and once it's showing boost it will hold 5 psi nice and even. Going in the opposite direction when boost is dropping and its going back into vacuum the engine will again stutter. Vacuum leak is what I'm thinking?

Here is what I found. The two large vacuum hoses on the Purge Control Valve have turned soft and jelly-like and literally won't stay on the PCV. I have removed as much of the vacuum routing as possible but left the rats nest in place. I don't think I routed anything incorrectly...but user error is always possible. Going on the assumption that everything is routed correctly; my question is why those vacuum lines have turned to jelly? Oil blowing through the hoses?

Possibly related and possibly just normal behavior. When I first turned the rebuilt engine over and letting it idle, warm up, etc. I was checking fluids and listening for bad noises. I noticed my oil filter got amazingly hot. Too hot to touch and I was worried enough that I shut the engine off. I couldn't find anything out of place so I went ahead and proceeded with breaking in the engine and I haven't noticed the oil filter or oil temps being unusually high. I've got an aftermarket oil temp gauge and the numbers stay in the normal range.