Had a request for more pics of the body side panhard bar mount.
panhard body mount - inside by
GySgtFrank, on Flickr
panhard body mount - outside by
GySgtFrank, on Flickr
It's one of the last of the G-Force Engineering panhard kits that I purchased when he was clearing his stock so he could retire. I installed it when I was doing my engine swap to free up the room for the over the axle dual exhaust. The Mustang bar I have is considerably longer. It could have been made to work, but I already had the G-Force bar. So I modified the G-Force provided axle mount to clear all the craziness at that end and left the body side mount alone. Good thing I picked up a driveline dial protractor, it has come in very handy.
You can see the temporary bar tack welded between the axle and frame in the inside view if you look close. Welded it solid once I had it in the correct stock position. Did this until I get all of my arms and swaybar finalized so that it does not move and mess me up. Then I'll grind out the tack welds, remove the temporary supports, and it should be in the proper position, well cross my fingers and hope anyway.