Ok guys not much doing my end
But I am planning ahead and making more room for my upper intercooler ducting
So out with the old slam panel and in with a new TGS one
I can now see 98% of the core
win
From the photo above you can see my
Plates that I'm using to tie in the bonnet catch and more of them below with sexy welds
Not really a good photo I will get more tomorrow when I get some time to finish it I may even tie into the lower front intercooler mount for added strength... But even now it feels stronger than what I had left there after cutting to get the cooler in place
Ps this photo I've just found on the pod website from last years rotorstock
More to follow