Rotary Car Club - View Single Post

WE3RX7 · 05-16-2008, 11:42 PM

Finally finished it up. I had to take the LIM off a few times because I kept forgetting little lines, etc. Luckily mazda kept most of the same gaskets, etc on this engine as the later NA 13Bs, so I had more than enough stuff laying around and it made the job nice.

I was running low on time towards the end, so there is still some things I'd like to clean more, but really it doesn't matter if its being sold... I just hate not having something look as good as possible!

Anyway... she's done. Tomorrow I will fire it up and see what happens.

05-16-2008, 11:42 PM	#6
WE3RX7 RCC Addict Join Date: Feb 2008 Location: VA Posts: 1,812 Rep Power: 19	Finally finished it up. I had to take the LIM off a few times because I kept forgetting little lines, etc. Luckily mazda kept most of the same gaskets, etc on this engine as the later NA 13Bs, so I had more than enough stuff laying around and it made the job nice. I was running low on time towards the end, so there is still some things I'd like to clean more, but really it doesn't matter if its being sold... I just hate not having something look as good as possible! Anyway... she's done. Tomorrow I will fire it up and see what happens. Last edited by WE3RX7; 02-04-2009 at 11:49 PM.