Rotary Car Club - View Single Post - FS: 2-1/16" Gauges

infernosg · 02-13-2014, 04:52 PM

Going with a different setup so I don't need these anymore. They were installed on my red FC for close to two years but the car never actually ran. Detailed information on the gauges can be found here: http://www.marshallinstruments.com/c.../scx_black.cfm.

Otherwise, here's the general info:
Brand: Marshall Instruments
Line: SCX (black on black)
Type: Electric, 270-degree sweep
Gauges: Oil temperature, oil pressure, and water temperature
Illumination: Red or white
Pointer: Red
Other features: Peak recall, high/low warning, warning 12V output, remote calibration button

Included is the gauge, flying lead harness, sending unit, and instructions. I only have one set of instructions for the temperature gauges as the setup is identical.

Full disclosure: one of the leads to one of the remote calibration buttons has separated (see below) but that's easily fixable with some solder and heat shrink tubing. I can fix this before shipping if needed.

Asking price: $70 each or $180 for all three.

I also have a generic universal metal gauge pod I'll throw in for free with purchase of all three gauges. Otherwise it's $20.

02-13-2014, 04:52 PM	#1
infernosg IT'S ALIVE! Join Date: Dec 2009 Location: Richmond, VA Posts: 811 Rep Power: 16	FS: 2-1/16" Gauges Going with a different setup so I don't need these anymore. They were installed on my red FC for close to two years but the car never actually ran. Detailed information on the gauges can be found here: http://www.marshallinstruments.com/c.../scx_black.cfm. Otherwise, here's the general info: Brand: Marshall Instruments Line: SCX (black on black) Type: Electric, 270-degree sweep Gauges: Oil temperature, oil pressure, and water temperature Illumination: Red or white Pointer: Red Other features: Peak recall, high/low warning, warning 12V output, remote calibration button Included is the gauge, flying lead harness, sending unit, and instructions. I only have one set of instructions for the temperature gauges as the setup is identical. Full disclosure: one of the leads to one of the remote calibration buttons has separated (see below) but that's easily fixable with some solder and heat shrink tubing. I can fix this before shipping if needed. Asking price: $70 each or $180 for all three. I also have a generic universal metal gauge pod I'll throw in for free with purchase of all three gauges. Otherwise it's $20. __________________ '86 Mazda RX-7 Base '79 Mazda RX-7 GS Last edited by infernosg; 06-13-2014 at 06:55 PM.