So this is what I spent an entire day doing. Just one little piece of tube, that's all. Right!
13B header 1 by
13B header 2 by
Kevin Frank, on Flickr
well besides the tube, I did get the O2 sensor bung welded in, so that's two things I guess.
I am modifying the Racing Beat 6 port header, that I already had, to fit in the midget. It will have to be a two piece design if I am to have any hope of ever getting it in and out of the car. This is the upper portion mating to a road race outlet flange. It will be mated to a lower section using the same type of flange and making an immediate 90 straight back. Needless to say there was lots of fiddling to get it just right so that everything would go where it needs to. Now that I have a better idea of what I will need, I ordered some more flanges, bends, and straight tube from Racing Beat to finish part of the exhaust system.