Quote:
Originally Posted by JL1RX7
Hard to say if they are using the computer to do the averaging or if it is true resistance that doing the work. It's been awhile since I read a cut sheet on level sensor. Most of the time the ones I work with are high or low level limit switches. Next week when I am bored I will read up on them.
|
I've been taking readings all week from the right side sender in order to get the right sender in my new lpg tank.
The readings below.
Fuel gauge reading
Full 47ohm
3/4 210ohm
1/2 243ohm
1/4 326ohm
Empty 326ohm
So I'm guessing this is not gonna be accurate if rx8 somehow averages out from two senders?
I noticed the reading of 326 never changed between below half and empty !!? Drove me crazy
Maybe the two senders merge their wires parallel and cld be measured at that point?