Quote:
Originally Posted by JL1RX7
Now since it is a averaging sensor I wonder if it only takes input from certain OHM readings. So say anything above 90 OHM it only reads from one side vs the other.
Most of the sensor's I use are for temperature across a large area. Not a split sensor system like this. But trying to see the logic of what they are trying to read, then using a sensor to read it. I could see it doing something like that.
|
I think I figured it.
The gauge cuts the circuit to the right sender once it gets below half. Much like how it activates the fuel light at near empty.
Then only reads level from the left.
My final readings were this
Full 7-9 together
3/4 55 together
1/2 142 left side only
1/4 200 left only
E 326 left only
I'm still not convinced it's 100% accurate but I think it's close enough to program a new single sender