Rotary Car Club - View Single Post - Gauge Pod Updates and the Best Way for Ordering Gauge Pods

Flyrx7 · 07-02-2008, 02:15 AM

I sent out emails on 6/29/08 to the people at the top of the waiting list to let them know that the last batch was done and ready to ship. Check your emails and spam filters just in case you were one of them. I have received a couple bounces so far.....so bad luck for some means good luck for the next guy.

Also of note, I'm underway with the next batch of pods as we speak.
This batch will be about 80% +/- of the waiting list, 52mm, 60mm, Left hand and Right hand pods.
I'm still waiting for some supplies to come in over the next week, but I'm starting in with the materials I have on hand.

I'll post updates as they occur.

Regards,
Frank

07-02-2008, 02:15 AM	#2
Flyrx7 Rotary Fanatic Join Date: May 2008 Location: WA State Posts: 168 Rep Power: 18	I sent out emails on 6/29/08 to the people at the top of the waiting list to let them know that the last batch was done and ready to ship. Check your emails and spam filters just in case you were one of them. I have received a couple bounces so far.....so bad luck for some means good luck for the next guy. Also of note, I'm underway with the next batch of pods as we speak. This batch will be about 80% +/- of the waiting list, 52mm, 60mm, Left hand and Right hand pods. I'm still waiting for some supplies to come in over the next week, but I'm starting in with the materials I have on hand. I'll post updates as they occur. Regards, Frank