OK. Since nobody can identify whether my injectors are high or low impedence by sight, I will need to go digging to find out again.
I wish I would write these things down.
So, my exhaust parts showed up today.
exhaust parts by
Kevin Frank, on Flickr
2 - 48" long straight pieces of 2"OD .120 wall tubing (The extra shorter piece is what I have left from my earlier adventures)
3 - 48" long pieces of perforated 409 SS tube (The ones in the cardboard tubes. I probably got more than I am going to need for this project, but they weren't that expensive.)
5 - 3" radius 180 degree mandrel bends (same tube as the straight pieces)
2 - 4" radius 180 degree mandrel bends (again, same tube as the straight pieces)
4 - SS Racing beat road race flanges
4 - Mild steel Racing beat road race flanges
5 - Exhaust gaskets for above flanges
The only pieces that I should need to complete the exhaust system now should be SS wool for muffler packing, more hangers, aluminum sheet for heat shielding, and SS sheet to make the muffler cases. I am not too sure that I want to total up what the exhaust system for this thing is going to end up costing. :shudders: