Quote:
Originally Posted by project86
So... I have the VDI open now. I thought that would help. Doesn't seem to have done anything for me. I just did a little looking around on the other forum and found out that the VDI doesn't have to be open all the time anyway.
The only other thing I found is that there is a vacuum nipple for the injectors that is supposed to help with atomization. I can't recall if I have that connected to a vac source or not though but im not sure that would cause my issues.
I'm truly at a loss now.
|
If that is left open, it'll cause a vac leak which could be the problem
Quote:
Originally Posted by project86
Slow going but i replaced plugs and wires last night. Seemed to help a bit but still no dice. AFM next? Coils?
|
Not to be the bearer of bad news but after seeing those plugs, it's time for a compression test.
__________________
-The Angry Stig-
DGRR 2009, 2011, 2012 & 2013 - Best FC
DEALS GAP!! WOOHOOOO!!!!!
2015 Audi S4 - Samantha - Zero Brap S4
2004 RX8 - Jocelyn - 196rwhp, 19mpg fuel to noise converter
2000 Jeep Cherokee Sport - Wifey mobile - Now with 2.5" OME lift and 30" BFG AT KO's! So it begins
1998 Jeep Cherokee - 5 spd, 4" lift, 33" BFG's - Rotary Tow Vehicle
1988 'Vert - In progress
1988 FC Coupe - Gretchen -The attention whore BEAST!
I'm a sick individual, what's wrong with you?
I'm pure Evil
I'm still insane, in the best possible way.
I think Brian's idea of romance is using lube.
Your rage caused the meteor strike in Russia. The Antichrist would be proud of his minion.
You win with your thread. Most everything
It's a truck with a steel gate on the back. Just a statement of fact
Motec M820, AIM dash, ported 13B-RE Cosmo, 6-spd trans, 4.3 Torsen, custom twin wg fully divided mani, Custom 4" split into 2x 3" exhaust, Custom HMIC, Custom custom custom custom I like to welder stuff....
No Bolt-ons allowed. Dyno'ed @
Speed1 Tuned by me - 405rwhp on WG.... WM50 cuming soon.
-Angry Motherf*cker Mode ENGAGED-