Rotary Car Club - View Single Post - Dropping in motor. Lining up input shaft with pilot bearing?

AHarada · 08-10-2008, 10:27 PM

Yes, I used a clutch alignment tool to hold the clutch in place while I tightened up the pressure plate bolts. It does have a few dowels, but I can't even get the motor to that point. The motor gets caught on something about an inch before that, and I can't see what it is.

08-10-2008, 10:27 PM	#3
AHarada Rotary Fanatic Join Date: Mar 2008 Posts: 162 Rep Power: 18	Yes, I used a clutch alignment tool to hold the clutch in place while I tightened up the pressure plate bolts. It does have a few dowels, but I can't even get the motor to that point. The motor gets caught on something about an inch before that, and I can't see what it is.