View Single Post
Old 09-30-2008, 07:43 PM   #1
Ender
rotors excite me
 
Ender's Avatar
 
Join Date: Mar 2008
Location: Iowa
Posts: 372
Rep Power: 18
Ender is on a distinguished road
Stock S4 TII springs and sway bar end links

From an '87 TII with right about 100,000 miles:
-all four coil springs: $40 shipped
-a pair of rear sway bar end links: $15 shipped, $25 shipped for all four end links

The bushings are shot, but the links are fine and the sleeves should be ok, but if you buy replacement OEM bushings I would assume the sleeves are built in. I can pull the front pair of end links off if you want them, too. I have the replacements waiting to be installed.



*Shipping prices to lower 48, shipping outside that region will be discussed on an individual basis.

I do have the original struts as well, and while I don't think they are blown, they are old and certainly aren't worth much. If you do want them I would take $25 plus shipping for all four. These may not be around for long as they are with a pile of other garage trash waiting to be exiled.
__________________
He isn't a killer. He just wins -- thoroughly.


'87 TII
240+ rwhp on my DIY streetport, ~13psi on stock turbo, Racing Beat REVTII exhaust
rTek 2.1 awaits a tune

Quote:
Originally Posted by need RX7
This is why I don't do politics, it's just one stupid thing after another.
360 gamertag: quick Tii

Last edited by Ender; 10-04-2008 at 02:28 PM. Reason: photos
Ender is offline   Reply With Quote