Quote:
Originally Posted by classicauto
Cost will vary but any machine shop can easily do it. When I needed to have the flange on my Greddy log manifold surface ground it cost me $40 at a local place.
Yeah if you can have them made cheaper just get them cut. Main reason I go to ATP is because when I'm doing a project like this, I'll just order everything I need since they have it all. Its just easier for me, but just do whatever's easiest/cheapest for you. If I could have that stuff made real local I would......
Yeah summit will have CHEAP mufflers. And don't sweat offset entry/exit killing flow. You should be able to see straight through if you hold the muffler up, but as I'm sure you can envision, sound get cancelled from bouncing around inside them vs. shooting through a tube.
|
Cheap as in quality, or cheap as in cost? I found some 304 stainless one's that are offset for about 76 each. Not a good buy? I think they're magnaflow.