Rotary Car Club - View Single Post - Question about single turbo vacuum diagrams

speedjunkie · 10-16-2008, 04:21 PM

No the EBC I have is the AVC-R, not the GReddy or Blitz or anything else. The APEX'i directions say to T from the NC port (on the solenoid valve) to the IC piping and side of the wastegate, but that hasn't worked for me, maybe because I've been using the UIM/LIM nipples and it's not getting a consistent reading. I have the BOV vac line going to the front of the UIM next to the throttle body, shouldn't that give the same reading as the rear nipples? And I thought there were only 2 nipples on the rear of the UIM near the throttle body?

Thanks for the input!

10-16-2008, 04:21 PM	#5
speedjunkie RCC Loves Me Not You Join Date: Mar 2008 Location: Colorado Springs, CO Posts: 2,089 Rep Power: 20	No the EBC I have is the AVC-R, not the GReddy or Blitz or anything else. The APEX'i directions say to T from the NC port (on the solenoid valve) to the IC piping and side of the wastegate, but that hasn't worked for me, maybe because I've been using the UIM/LIM nipples and it's not getting a consistent reading. I have the BOV vac line going to the front of the UIM next to the throttle body, shouldn't that give the same reading as the rear nipples? And I thought there were only 2 nipples on the rear of the UIM near the throttle body? Thanks for the input!