[joeyfc3s]

get the backplate,compressor and compresor wheel,all this parts bolt right on to the stock TURBO CHRA and HOTSIDE,replace the stock 270 carbon seal for a 360 dynamic seal for better oil flow,get a gapless rear shaft seal(no nasty oil leaks)and new bearings(meassure the shaft for wear cause you can get difference size bearings and even you can get them with bigger oil holes for more lubrication)if you dont have any play just reuse your old bearings,is also recomended that you get the assembly balance but it will work fine without doing it,the 360 dynamic seals they go for around 80.00 bucks,the gapless shaft seal 20.00 and the bearings around 25.00.Building a hybrid turbo is not that hard and expensive if you know from where to get the parts and how to assemble them.