No Limit Industries is helping me get a half bridge motor running. It was built by a reputable shop, and has like 100 miles on it. The motor is installed in the car now, and we were about to install the intake manifold/carb setup. One of the guys stuck his finger into the intake ports and felt something out of place.
It looks like there's a little piece of gasket material hanging into the intake port. When we felt inside the other ports, they also had some material. I assume it is one of the water seals, that no longer has a place to seat because of the porting. I don't want to rip it out for fear that the whole seal will come with it. I don't want to leave it because it seems like an obstruction to flow.
I don't know enough about the porting procedures to know if this is bad or not. Any tips/advice/information would be greatly appreciate it. I'll call the builder this afternoon to get his opinion on it.
