Rotary Car Club - View Single Post - Need a T2 Front Iron/How to grind out diffuser

TehMonkay · 01-02-2009, 04:24 PM

I need 1 T2 front iron, the motor it's going on is all S5 stuff except the rear iron, but I don't think it matters too much as long as it hasn't been bridged, it's going in a street port motor. One i had got cut a little too deep.

Also, what should I do to grind out a diffuser(n/a housing)? Can i use an electric drill? What kind of bit should i use?

01-02-2009, 04:24 PM	#1
TehMonkay Rotary Fanatic Join Date: Apr 2008 Location: Louisville, KY Posts: 302 Rep Power: 18	Need a T2 Front Iron/How to grind out diffuser I need 1 T2 front iron, the motor it's going on is all S5 stuff except the rear iron, but I don't think it matters too much as long as it hasn't been bridged, it's going in a street port motor. One i had got cut a little too deep. Also, what should I do to grind out a diffuser(n/a housing)? Can i use an electric drill? What kind of bit should i use? __________________ My car blows up everytime I start it, it's rotary