Rotary Car Club - View Single Post

Garfinkles Motor Works · 03-16-2008, 10:21 PM

Thank you Phil ,I am now on here .I have two Engine torque braces ready to ship ,They have been going out at a steady rate .I will start making more soon . Oil pan braces are being made now , I will sell them after Speed for Sale sells out or they may order more .I am thinking about making an idler to replace the air pump if there is interest .It is not a copy of the one I made for my car ,many have seen it , but the design is very good, better than any of the ones I have seen picts of . I think I can make it to sell for way under $ 200 but time will tell .

03-16-2008, 10:21 PM	#6
Garfinkles Motor Works RCC Contributor Join Date: Mar 2008 Posts: 535 Rep Power: 18	Thank you Phil ,I am now on here .I have two Engine torque braces ready to ship ,They have been going out at a steady rate .I will start making more soon . Oil pan braces are being made now , I will sell them after Speed for Sale sells out or they may order more .I am thinking about making an idler to replace the air pump if there is interest .It is not a copy of the one I made for my car ,many have seen it , but the design is very good, better than any of the ones I have seen picts of . I think I can make it to sell for way under $ 200 but time will tell .