[My5ABaby]

Originally Posted by N.RotaryTech

LED's in general I guess.
Phoenix has a great idea about the rotor shapes.

I would go with any pattern of lines or circles just as long as it still resembles S5 circle lights.

Here's some S5 tails done with LEDs. Like I said, everyone basically does the same thing.

http://www.rx7club.com/showthread.ph...LED%2A+tail%2A

I personally have a good idea that will probably be my next project. Considering I don't particularly like the S5 lights, I'll probably sell them after modifying. For now it's a secret though.

Originally Posted by DJMOJO

not a huge fan of s4 lights myself BUT i must give props on creativity and workmanship, the only thing i have to say is i really hope you end up cleaning up the rats nest of wires but other than that it looks clean! good job!

I've already cleaned it up some by putting both PWMs into a Radio Shack enclosure. In general though there's only so much I can do. I could, and likely will wrap them once I make sure everything is working correctly. But until then, you can't tell they're there with the carpet up.