View Single Post
Old 07-01-2009, 08:14 AM   #4
ProjectD
Rotary Fan in Training
 
Join Date: Feb 2008
Posts: 70
Rep Power: 18
ProjectD is on a distinguished road
Polished UIM $150
Greddy 2 row FMIC w/ HKS SSQ BOV $700
Defi mechanical Boost gauge $130
HKS EVC IV electronic boost controller $150
Single turbo engine harness with FJO injector driver (low miles) $400
Aspec GT3574 turbo .96 A/R $550
Tial 46mm WG $250
Ported rx7store single turbo manifold with tial 46mm wg flange $150
NEW air intake temp sensor $40
Bosch 1680cc injectors cleaned and flow tested (5) $ 65each
Lucas/RC 120lb injectors (1 pair) $80
Fluidyne Radiator w/ stock fan setup $275
FC leading ignition coil (3) $40 each
5 speed tranny no grinds $300
Supra TT Fuel pump(s) 2 $140 shipped (each)
Big Boy fuel setup (black anodized top feed rails, sard FPR w/gauge and mounting bracket w/ harware. 2 edlebrock 40 micron stainless replaceable stainless steel fuel filters, All lines and fittings required for install. hose is black nylon with SS reinforced braid. This fuel setup will handle whatever you wanna run though it from pumpgas to race gas and even E85. $500 (i'll even throw in a pair of1680cc injectors
Also willing to part out the fuel system...
Supra TT Fuel pump(s) 2 $140 shipped each
Ebay Engine torque damper painted black $50
Thermostat housing with AST delete $50
Throttle body $65
LIM $50
Gotham racing Short shifter $145
BDC ported half bridge REW $2000
Gotham racing polyurathane motor mounts $100
__________________
ProjectD is offline   Reply With Quote