Rotary Car Club - View Single Post

87TurboII · 07-25-2009, 04:47 PM

This is a stupid question I am sure but I would hate to put it all back together just to find out something is not right.

I pulled the old blown engine and just installed the new engine. I did not pull the transmission so I had to try and align it and slide it onto the transmission.

Is there a way to see if they are all together properly? the engine is up against the transmission so I assume the splines on the clutch and transmission must be aligned but should the rear tires spin if the eccentric shaft is turned whiles its in gear?

Just want to double check with others who have probably done this more times than me.

Thanks

07-25-2009, 04:47 PM	#1
87TurboII Rotary Fan in Training Join Date: Jul 2008 Location: Texas Posts: 45 Rep Power: 0	Engine Install Check This is a stupid question I am sure but I would hate to put it all back together just to find out something is not right. I pulled the old blown engine and just installed the new engine. I did not pull the transmission so I had to try and align it and slide it onto the transmission. Is there a way to see if they are all together properly? the engine is up against the transmission so I assume the splines on the clutch and transmission must be aligned but should the rear tires spin if the eccentric shaft is turned whiles its in gear? Just want to double check with others who have probably done this more times than me. Thanks __________________ 1987 Turbo II