Rotary Car Club - View Single Post

BigIslandSevens · 08-26-2009, 06:54 PM

Like I said. It is not perfect. But for a quick budget resto, I think I will proceed. Although the flash really shows where I didn't get good coverage. Afraid of runs if I went closer or longer in those tight spots. hopefully they will not be to embarrasing. The wheel wells and shock tower inners are going to be blacked out. Either truckbed coating or rubberized undercoat.So is the bottom of the frame rails and the trans tunnel area

Here are some color shots. No clearcoat on it yet.1 quart of color, or 3 good coats.
Opinions on whether to proceed are welcome. Or try to cover the few small areas.

08-26-2009, 06:54 PM	#11
BigIslandSevens Rotary Fanatic Join Date: Feb 2008 Location: Denver, NC Posts: 201 Rep Power: 18	Like I said. It is not perfect. But for a quick budget resto, I think I will proceed. Although the flash really shows where I didn't get good coverage. Afraid of runs if I went closer or longer in those tight spots. hopefully they will not be to embarrasing. The wheel wells and shock tower inners are going to be blacked out. Either truckbed coating or rubberized undercoat.So is the bottom of the frame rails and the trans tunnel area Here are some color shots. No clearcoat on it yet.1 quart of color, or 3 good coats. Opinions on whether to proceed are welcome. Or try to cover the few small areas. Last edited by BigIslandSevens; 08-26-2009 at 06:57 PM.