Rotary Car Club - View Single Post - Can i use a low/high-imp injector combination?

Justen · 10-04-2009, 03:16 PM

So after my rebuild, i put my stock injectors back in when installing the motor again. But I ordered a pair of bosch 1600cc low-imp monsters to replace my secondaries, haven't put them in yet though. I'd like to install them before i go in for a tune.

What I'm asking is for someone to confirm that i do have stock high-imp injectors in my 90' Turbo II. The stock ones are Denso 550cc reds.

...And is it possible to use high-imp primaries but low-imp secondaries in the same car?

If anyone knows where i can find a write up of how to solder in the resistors, that would be awesome. Thanks.

10-04-2009, 03:16 PM	#1
Justen In Too Deep Join Date: Jun 2009 Location: Clifton, NJ Posts: 112 Rep Power: 16	Can i use a low/high-imp injector combination? So after my rebuild, i put my stock injectors back in when installing the motor again. But I ordered a pair of bosch 1600cc low-imp monsters to replace my secondaries, haven't put them in yet though. I'd like to install them before i go in for a tune. What I'm asking is for someone to confirm that i do have stock high-imp injectors in my 90' Turbo II. The stock ones are Denso 550cc reds. ...And is it possible to use high-imp primaries but low-imp secondaries in the same car? If anyone knows where i can find a write up of how to solder in the resistors, that would be awesome. Thanks.