Quote:
Originally Posted by EJayCe996
I should try and make progress tonight but I think the Ketel One is catching up (seeing as I haven't eaten anything since pho at noon)... Tomorrow is gonna be a cram between Class ending at noon and the RX-7 meet/cruise happening at 7pm. I finally got another jack that stays "low profile" for longer than just the jack point.... Man my fenders have some damage from that bullshit over the years. Not to mention it is a helluva lot safer too. My old Jack creeped down out of the box brand new!
|
I always jack from the center of the front subframe or the rear diff. Jack stands go under the lower control arm rear pivot point where then mount on the subframe and the arms heading inward on the front of the rear subframe....... you don't use jack stands? Just the jack? That's a little worrysome.
T-minus 60 hours
Antman...... you thinking about heading out?
__________________
-The Angry Stig-
DGRR 2009, 2011, 2012 & 2013 - Best FC
DEALS GAP!! WOOHOOOO!!!!!
2015 Audi S4 - Samantha - Zero Brap S4
2004 RX8 - Jocelyn - 196rwhp, 19mpg fuel to noise converter
2000 Jeep Cherokee Sport - Wifey mobile - Now with 2.5" OME lift and 30" BFG AT KO's! So it begins
1998 Jeep Cherokee - 5 spd, 4" lift, 33" BFG's - Rotary Tow Vehicle
1988 'Vert - In progress
1988 FC Coupe - Gretchen -The attention whore BEAST!
I'm a sick individual, what's wrong with you?
I'm pure Evil
I'm still insane, in the best possible way.
I think Brian's idea of romance is using lube.
Your rage caused the meteor strike in Russia. The Antichrist would be proud of his minion.
You win with your thread. Most everything
It's a truck with a steel gate on the back. Just a statement of fact
Motec M820, AIM dash, ported 13B-RE Cosmo, 6-spd trans, 4.3 Torsen, custom twin wg fully divided mani, Custom 4" split into 2x 3" exhaust, Custom HMIC, Custom custom custom custom I like to welder stuff....
No Bolt-ons allowed. Dyno'ed @
Speed1 Tuned by me - 405rwhp on WG.... WM50 cuming soon.
-Angry Motherf*cker Mode ENGAGED-