Rotary Car Club - View Single Post

rx4ur7 · 10-07-2009, 03:52 PM

Otterbob, do you have any support going forward? Is that the Curt? Looks like it is made with channel.
We should be able to offer one similar to the Curt but the support that goes forward will be above the cross member. So the cross member will be taking the load, not just the welds. We will also offer small receiver. 210 at the most. Less for ball only. Should be able to do better if there are a few people interested. Ratings will be the same as the curt 1000lb max tow and 100lb tongue.

The Curt does require drilling. We are kicking around a couple of options. Besides the similar to curt design one that bolts to the body cross member the u bolts are used on the bumper shock shafts. This system is used with some bolt on trailer hitches for trucks.

10-07-2009, 03:52 PM	#7
rx4ur7 Rotary since 1972 Join Date: Nov 2008 Location: Tucson Posts: 231 Rep Power: 17	Otterbob, do you have any support going forward? Is that the Curt? Looks like it is made with channel. We should be able to offer one similar to the Curt but the support that goes forward will be above the cross member. So the cross member will be taking the load, not just the welds. We will also offer small receiver. 210 at the most. Less for ball only. Should be able to do better if there are a few people interested. Ratings will be the same as the curt 1000lb max tow and 100lb tongue. The Curt does require drilling. We are kicking around a couple of options. Besides the similar to curt design one that bolts to the body cross member the u bolts are used on the bumper shock shafts. This system is used with some bolt on trailer hitches for trucks. Last edited by rx4ur7; 10-07-2009 at 03:57 PM.