How to remove OMP inlet nozzles on inlet manifold - Rotary Car Club

		Rotary Car Club > Tech Discussion > Carburetors and Carb Tuning..
How to remove OMP inlet nozzles on inlet manifold

Mark Forums Read

Carburetors and Carb Tuning.. All info about old school carb set ups..

Prev

Previous Post

Next Post

Next

03-28-2011, 06:58 PM	#1
RX MIDGET MG rocket Join Date: Oct 2010 Location: Victoria Australia Posts: 40 Rep Power: 0	How to remove OMP inlet nozzles on inlet manifold Hi, After disconnecting the OMP I am left with the 2 brass nozzlesbetween the 48IDA and manifold. Is there a trick to removing them without damage? Figure it would look better to remove them than cap them with silicone. Thoughts?

Bookmarks

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -5. The time now is 02:53 AM.