looking for IC parts

speedjunkie · 05-29-2010, 03:12 PM

I know this isn't rotary specific but I didn't know where else to put it.

Anyway, as the title says, I'm looking for a website or something that has intercooler parts. The reason being that my current IC end tanks are not efficient and I want to make a new one. Take a look at the pic to see for yourself...

I'd like to have some end takes similar to this...

...but I'd like to see what else is out there before I commit myself to these, and actually if they could flow a bit smoother than these I'd like that too, maybe have more of an angle where the air enters and exits. If I can't find anything closer to what I need then I'll definitely get these though because they're already leaps and bounds better than what I have now.

I've done google searches and so far I haven't seen anything like what I need, and until I do, it leads me to believe I need to have it made.

Also, I think I read something within the last couple months or so about a new IC core design, has anyone heard anything about that? Supposedly it's better than bar and plate. I could be mistaken, it's been a while since I read it and I'm probably just "remembering" things that don't actually exist haha.

speedjunkie · 06-05-2010, 07:12 PM

After looking through pages and pages of crap I think I might have found some stuff that should work.

http://www.avoturbo.com/avoshop/inde...th=170_178_204

Some of it is kinda expensive and it's in Australia, but some of them are dead on for size.

05-29-2010, 03:12 PM	#1
speedjunkie RCC Loves Me Not You Join Date: Mar 2008 Location: Colorado Springs, CO Posts: 2,089 Rep Power: 20	looking for IC parts I know this isn't rotary specific but I didn't know where else to put it. Anyway, as the title says, I'm looking for a website or something that has intercooler parts. The reason being that my current IC end tanks are not efficient and I want to make a new one. Take a look at the pic to see for yourself... I'd like to have some end takes similar to this... ...but I'd like to see what else is out there before I commit myself to these, and actually if they could flow a bit smoother than these I'd like that too, maybe have more of an angle where the air enters and exits. If I can't find anything closer to what I need then I'll definitely get these though because they're already leaps and bounds better than what I have now. I've done google searches and so far I haven't seen anything like what I need, and until I do, it leads me to believe I need to have it made. Also, I think I read something within the last couple months or so about a new IC core design, has anyone heard anything about that? Supposedly it's better than bar and plate. I could be mistaken, it's been a while since I read it and I'm probably just "remembering" things that don't actually exist haha.

06-05-2010, 07:12 PM	#2
speedjunkie RCC Loves Me Not You Join Date: Mar 2008 Location: Colorado Springs, CO Posts: 2,089 Rep Power: 20	After looking through pages and pages of crap I think I might have found some stuff that should work. http://www.avoturbo.com/avoshop/inde...th=170_178_204 Some of it is kinda expensive and it's in Australia, but some of them are dead on for size.