Boost prepping 51ida Weber

[sen2two]

Im looking to boost prep my 51ida weber (7-10psi max on stock s5 turbo). From what I read I need to do 2 things for sure.*

1. Vent the fuel bowl into the carb hat so it sees the equal pressure. (Line from fuel bowl to carb hat area?)

2. Swap the brass float for a plastic float. Because the brass float will crush above 6psi. The plastic float is good until 20psi.

Other things I have read are unclear. Its obvious that i need to seal any and all areas that can leak. But what areas do these include?*

1. What else besides the "hat" needs to be a sealed?

2. Do I have to seal the throttle shaft?

3. Is there any other modifications to the weber that need to be addressed?*

I have everything else ready to go. I just want to be sure I get my weber in order before setting it all up.

[sen2two]

No help here?

[730RWHP12A]

3.3 needle valve, machine carb top to flow more fuel, enlarge float bowl, if the carb hat is made properly you dont need to vent float bowl, (like the carb hats i sell) phenolic float.. i sell i complete IDA boost prep kit, comes with all parts needed and instructions..