Door latch trouble - Page 2

dudemaaan · 10-07-2009, 09:05 PM

Might check your other side to make sure it's alright too.

speedjunkie · 10-07-2009, 10:32 PM

I swapped the handles on both sides, and also cleaned up all the pieces with WD40 and a rag, so there shouldn't be any binding issues now. Although it seems that the new handles are sticking a bit and won't go all the way back down on their own, but I figure that will go away after a while. And it's not much of a concern to me at this point, at least the handle is working again haha.

rx4ur7 · 10-08-2009, 12:11 AM

Most common failure. Mazda has had to make improvements.

speedjunkie · 10-08-2009, 10:22 AM

Yeah I'm actually surprised mine lasted so long. I got aluminum handles from JKL Racing.

http://shop.jklre.com/products/fd-al-handles

I'm not sure what to say about the other metal piece bending, I can't really control that I guess haha.

R1_Stormrider · 10-23-2009, 09:08 AM

if anyone needs a replacement door handle, i got one off curtis james for cheap compared to stealership prices of 250+. im not sure how the guy would like his cell # posted on a forum, so just PM and ill share it

10-07-2009, 09:05 PM	#16
dudemaaan Rotary Fanatic Join Date: Mar 2008 Location: Brenham, TX Posts: 335 Rep Power: 18	Might check your other side to make sure it's alright too. __________________ 500+ HP thanks to: Fast reacting IAT sensor thread! Mechanical Pre-turbo Water Injection Thread Dual Stock fuel pumps Thread T2 differential swap!

10-23-2009, 09:08 AM	#20
R1_Stormrider Traveling in Stygian Join Date: May 2009 Location: TX Posts: 26 Rep Power: 0	if anyone needs a replacement door handle, i got one off curtis james for cheap compared to stealership prices of 250+. im not sure how the guy would like his cell # posted on a forum, so just PM and ill share it __________________ *93 RX-7 FD R1*

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

10-07-2009, 10:32 PM	#17
speedjunkie RCC Loves Me Not You Join Date: Mar 2008 Location: Colorado Springs, CO Posts: 2,089 Rep Power: 20	I swapped the handles on both sides, and also cleaned up all the pieces with WD40 and a rag, so there shouldn't be any binding issues now. Although it seems that the new handles are sticking a bit and won't go all the way back down on their own, but I figure that will go away after a while. And it's not much of a concern to me at this point, at least the handle is working again haha.

10-08-2009, 12:11 AM	#18
rx4ur7 Rotary since 1972 Join Date: Nov 2008 Location: Tucson Posts: 231 Rep Power: 17	Most common failure. Mazda has had to make improvements.

10-08-2009, 10:22 AM	#19
speedjunkie RCC Loves Me Not You Join Date: Mar 2008 Location: Colorado Springs, CO Posts: 2,089 Rep Power: 20	Yeah I'm actually surprised mine lasted so long. I got aluminum handles from JKL Racing. http://shop.jklre.com/products/fd-al-handles I'm not sure what to say about the other metal piece bending, I can't really control that I guess haha.