FC3S Murray's never ending build.

Rotary Inspired · 05-28-2010, 10:14 PM

Ted I know you are big on tuning w/ the EGT gauge and one of the few I know of that are brave enough to use only the EGT to tune. What are you looking for in the logs of the EGT for the cause of this?

What are your thoughts on the cracking of plates. Everything I have seen points to a misfire which causes more strain on the block. I am wondering if the addition of the aux injection could have a cause on this. IMO there is not a huge need for aux injection at the 400 hp level. If you proceed upwards getting close to 500 is where it would be good investment.

Always willing to listen. Thanks in advance.

05-28-2010, 10:14 PM	#11
Rotary Inspired Rotary Fan in Training Join Date: Feb 2008 Location: SW OKC Posts: 75 Rep Power: 18	Ted I know you are big on tuning w/ the EGT gauge and one of the few I know of that are brave enough to use only the EGT to tune. What are you looking for in the logs of the EGT for the cause of this? What are your thoughts on the cracking of plates. Everything I have seen points to a misfire which causes more strain on the block. I am wondering if the addition of the aux injection could have a cause on this. IMO there is not a huge need for aux injection at the 400 hp level. If you proceed upwards getting close to 500 is where it would be good investment. Always willing to listen. Thanks in advance. __________________ If you wanna become ASE certified buy the RX7.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode