|
|||||||
| Show your rotary car build up. Show off your Rotary Car build! |
|
|
Thread Tools | Display Modes |
|
|||||||
| Show your rotary car build up. Show off your Rotary Car build! |
|
|
Thread Tools | Display Modes |
09-11-2017, 03:09 PM
|
#5 | |
|
Rotary Fanatic
Join Date: Jul 2011
Location: Jacksonville, FL
Posts: 273
Rep Power: 15  |
Set aside a weekend off work to get the engine swapped over. While I was at it I put in a whole new Exedy clutch setup including master/slave and hard/braided lines. Also decided to install a lightweight Fidanza flywheel since I had everything out of the car and knew I'd regret not doing it in the future.
After getting the car towed over to my house I worked on getting my RB exhaust back on, and getting my Megasquirt harness installed. I picked up a relay box from Stu Kelley Motorsports to clean up the install a bit.
__________________
Quote:
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode