|
|||||||
| RX-7 1st Gen Specific (1979-85) RX-7 1979-85 Discussion including performance modifications and technical support sections |
|
|
Thread Tools | Display Modes |
|
|||||||
| RX-7 1st Gen Specific (1979-85) RX-7 1979-85 Discussion including performance modifications and technical support sections |
|
|
Thread Tools | Display Modes |
10-10-2008, 09:16 AM
|
#7 |
|
Non Member
Join Date: Jun 2008
Posts: 310
Rep Power: 18  |
All 1st gen and earlier rotaries have a bolt on pulley with the timing marks on it. This pulley will fit the front hub any of 4 ways, as the bolt pattern is totally square, like a wheel & hub. The upside to these engines, they all have 3mm apex seals, or wider if you go old enough.
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode