Go Back   Rotary Car Club > Tech Discussion > RX-7 3rd Gen Specific (1993-2002)

RX-7 3rd Gen Specific (1993-2002) RX-7 1993-2002 Discussion including performance modifications and Technical Support Sections.

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 10-15-2008, 09:45 AM   #2
cewrx7r1
The Judge
 
Join Date: Feb 2008
Posts: 196
Rep Power: 18
cewrx7r1 is on a distinguished road
This is how I have my Blitz EBC hooked up after trying another way.
It works perfectly with no spiking.

Pressure source for the EBC unit comes from the rear of the UIM near the map sensor source. You want the two to read equal pressures.

Pressure source for the side of the wastegate and for the solenoid "in" comes from the TB elbow which has been tapped and "Teed". This pressure is closer to the pressure for the EBC and map sensor and less than before the IC.

The solenoid out goes to the top of the WG.

I use a 10lb WG spring and run 11, 13, 15, 16 psi boost as my EBC has four settings.
cewrx7r1 is offline   Reply With Quote
 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:34 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com