Any experience with these intake manifold gaskets?

AHarada · 12-14-2008, 03:43 AM

I made the mistake of re-using the stock metal intake manifold gaskets during my rebuild and I ended up with a fuel smell and issues with that. So I pulled the twins and both manifolds and the metal gasket from the LIM to the engine was wet and there was fuel getting past it.

Looking at new gaskets for the intake manifolds I came across these "thermal barrier" ones on ebay.

Does anyone have experience with them? They are cheaper than OEM, and are supposedly reusable, so if they seal well on their own, then I am sold.

http://cgi.ebay.com/ebaymotors/93-95...Q5fAccessories

12-14-2008, 03:43 AM	#1
AHarada Rotary Fanatic Join Date: Mar 2008 Posts: 162 Rep Power: 18	Any experience with these intake manifold gaskets? I made the mistake of re-using the stock metal intake manifold gaskets during my rebuild and I ended up with a fuel smell and issues with that. So I pulled the twins and both manifolds and the metal gasket from the LIM to the engine was wet and there was fuel getting past it. Looking at new gaskets for the intake manifolds I came across these "thermal barrier" ones on ebay. Does anyone have experience with them? They are cheaper than OEM, and are supposedly reusable, so if they seal well on their own, then I am sold. http://cgi.ebay.com/ebaymotors/93-95...Q5fAccessories

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode