RTEK Tuning?

Max777 · 01-28-2009, 10:57 PM

Thank you for the Tech support, it's really helpful so far!

About VDI: Will the VDI valve work fine if I just leave the vaccum diaphragm unconnected? Or is no vaccum for low end? I know it turns on at 5000 rpm, but what do I do to make sure it's in the proper place on the intake?

What I'm trying to say, is that if I dont make the vdi valve work again, wont it be in the "closed positon" and rob hi rpm power? or does it "close" at 5000 and up? I'm confused.

PS: It seems like the VDI valve of the middle intake is identical to the "roller ITB valve" setup where instead of pancake shaped butterfiles, you have a tubular roller that twists to open and close airflow.

01-28-2009, 10:57 PM	#5
Max777 Pirate Join Date: Mar 2008 Location: Central IL Posts: 1,323 Rep Power: 19	Thank you for the Tech support, it's really helpful so far! About VDI: Will the VDI valve work fine if I just leave the vaccum diaphragm unconnected? Or is no vaccum for low end? I know it turns on at 5000 rpm, but what do I do to make sure it's in the proper place on the intake? What I'm trying to say, is that if I dont make the vdi valve work again, wont it be in the "closed positon" and rob hi rpm power? or does it "close" at 5000 and up? I'm confused. PS: It seems like the VDI valve of the middle intake is identical to the "roller ITB valve" setup where instead of pancake shaped butterfiles, you have a tubular roller that twists to open and close airflow. __________________ Rotaries:They are NOT that complicated!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode