|
|||||||
| RX-7 1st Gen Specific (1979-85) RX-7 1979-85 Discussion including performance modifications and technical support sections |
|
|
Thread Tools | Display Modes |
|
|||||||
| RX-7 1st Gen Specific (1979-85) RX-7 1979-85 Discussion including performance modifications and technical support sections |
|
|
Thread Tools | Display Modes |
11-09-2009, 09:38 AM
|
#2 |
|
Waffles - hmmm good
Join Date: Aug 2008
Location: Huntersville, NC
Posts: 757
Rep Power: 0  |
I just measured a rear end I have laying around and its 57 inches from the hub face to hub face. I measured the distance from the outside edges of each brake backing plate, 54 inches. Then I measured the distance from the outside edge of the backing plate to the edge of axle flange, 1.5 inches. So 54 + (2*1.5) = 57 inches. This is an SA rearend but should be the same for 81-83 FB axles for sure. Not sure if the GSL or SE axles are any different.
__________________
1980 GS stockport, Fat Nikki, RB Dual Facetfuel pumps, Holley regulator, RB Street port exhaust, 2GDFIS, MR2 MK I electric fans, 2G strut bar, relayed fans, lights and fuel pump, LEDs Project Fat Nikki Budget 12A rebuild Video setup < $30.00 |
|
|
| Bookmarks |
|
|
Threaded Mode