|
|||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
|
|
Thread Tools | Display Modes |
|
|||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
|
|
Thread Tools | Display Modes |
06-09-2010, 07:13 PM
|
#9 |
|
IT'S ALIVE!
Join Date: Dec 2009
Location: Richmond, VA
Posts: 811
Rep Power: 16  |
End results attached below. Pictures show the 3/4" square tubing I initially used but that resulting in a seating position that was too high. I ended up using some 1/4"x1" flat stock (needed to be thickn enough to clear some features on the stock brackets) and everything is good. The end result is essentially the same (only seating height changed).
|
|
|
| Bookmarks |
|
|
Threaded Mode