wheel/tire fitment pic thread

[speedjunkie]

My third and current setup...
Wheels- Enkei RPF1
Sizes/offsets- 18x10 +38 F, 18x10.5 +15 R
Tires- Nitto NT555RII
Sizes- 285/35-18 F, 305/35-18 R
Optional info- Flared the rear fenders a hell of a lot more (probably about 2 inches past stock at this point), camber I believe is about -1.5* front and -1* rear, but I don't remember for sure, STANCE coilovers still.




Notes on this setup...these tires, I feel, are way too tall. The 285/35 fits the 10" pretty well width-wise, but it's just too tall. And the 305/35 bulges out a bit on the 10.5, which would be OK if, again, the tire wasn't too tall. I can't tell if there is rubbing when I'm driving it, but when I'm stopped there is tire residue on the rear fenders where the end of the lip (flare) ends on the stock fender. I believe there is rubbing on the front fenders too but I can't tell for sure. I DO know that the tires rub the frame in front of the wheel on one side, driver's side IIRC. I was thinking about just putting a spacer on there and see what happens but decided to just get smaller tires, and since I wanted a new set of wheels anyway that I'd just get new wheels too haha. I have some Shine 20+ wide front fenders but I haven't put them on yet. I've test fit them and this front setup leaves about 5-10mm of clearance.