GTUs 20B N/A Build Thread

GtoRx7 · 02-18-2011, 12:50 AM

This shows the internal teflon sheets

Milling the actuator grooves

Placement of the 4 ball bearing support system, and rounded the inside slider

Test assembly together with actuators

Showing movement of slide throttle

Hand bending curved end caps

Test assembly with radiuses on ends

Hand fitting and clearancing of the end caps

Smoothed and matched curved surfaces

Finished and polished slide

Countersunk plate bottoms, for spring perch. Much stronger than tapped aluminum

Exploded view of all the parts finished to the slide throttle setup

Finished assembly with button head stainless hardware

Air horns placed, just to give a idea of what it will look like fully finished

02-18-2011, 12:50 AM	#10
GtoRx7 Rotary Fanatic Join Date: Jul 2008 Posts: 151 Rep Power: 17	This shows the internal teflon sheets Milling the actuator grooves Placement of the 4 ball bearing support system, and rounded the inside slider Test assembly together with actuators Showing movement of slide throttle Hand bending curved end caps Test assembly with radiuses on ends Hand fitting and clearancing of the end caps Smoothed and matched curved surfaces Finished and polished slide Countersunk plate bottoms, for spring perch. Much stronger than tapped aluminum Exploded view of all the parts finished to the slide throttle setup Finished assembly with button head stainless hardware Air horns placed, just to give a idea of what it will look like fully finished __________________ DEFINED AUTOWORKS Where concept meets results Black 1994 FD 4-rotor 610rwhp all motor Red 1970 Mazda R-100 with 10a Black 1974 Mazda Rx4 Black 1984 Gsl-SE 13b-re streetport 230rwhp