tips on building a high rpm motor

IH8DSM · 08-03-2011, 02:19 AM

so far the engine ive planned to build is this
-s4 turbo motor ran as a na bridge ported(used housings/irons)
-s5 rotors
-race rotor bearings
-rx8 eshaft
-rx8 front and rear stationary gears
-cryo treated 2mm apex seals atkins
-cryo treated side seals atkins
-solid corner seals
-new apex seal springs, corner seal springs and side seal springs
-aluminum light weight flywheel
-rotating assembly balanced

So with that being said is there anything i should lookout for when it comes to either building/running this motor, should i change or add any parts to the list?

08-03-2011, 02:19 AM	#1
IH8DSM RCC Contributor Join Date: Mar 2008 Posts: 610 Rep Power: 18	tips on building a high rpm motor so far the engine ive planned to build is this -s4 turbo motor ran as a na bridge ported(used housings/irons) -s5 rotors -race rotor bearings -rx8 eshaft -rx8 front and rear stationary gears -cryo treated 2mm apex seals atkins -cryo treated side seals atkins -solid corner seals -new apex seal springs, corner seal springs and side seal springs -aluminum light weight flywheel -rotating assembly balanced So with that being said is there anything i should lookout for when it comes to either building/running this motor, should i change or add any parts to the list? __________________ 85 rx7 gsl-se - AA tags/ never ending project will never run