Any tricks to getting front pulley hub bolt off?

speedjunkie · 10-18-2011, 10:29 PM

A few years ago I broke mine loose by using a piece of angle iron with holes, but I didn't have a flywheel stopper back then. I also had it sitting on the ground though, and it did tilt a little bit but mine probably wasn't as tight as yours. Maybe using the angle iron and putting it on the ground will help though. As long as you can keep the engine from twisting with it. But the impact gun should help too. Sorry, I'm not much help haha.

10-18-2011, 10:29 PM	#2
speedjunkie RCC Loves Me Not You Join Date: Mar 2008 Location: Colorado Springs, CO Posts: 2,089 Rep Power: 20	A few years ago I broke mine loose by using a piece of angle iron with holes, but I didn't have a flywheel stopper back then. I also had it sitting on the ground though, and it did tilt a little bit but mine probably wasn't as tight as yours. Maybe using the angle iron and putting it on the ground will help though. As long as you can keep the engine from twisting with it. But the impact gun should help too. Sorry, I'm not much help haha.