My '76 Rx-4 hardtop build.

Buggy · 03-10-2012, 05:03 PM

I got the front suspension and brakes all assembled the other night and got the car back down on its wheels. My fear that it was going to be too low was then confirmed. It looks mean, but unfortunately I think it is going to have rubbing issues with the fenders when turning. I may have to make spacer plates to go between the camber plates and the strut towers to raise the front end back up a bit. I also stripped down the whole rear axle to get it ready to swap in and took measurements off of the rear axle to give to the guy that is building the leaf springs. Picture time!
DSC00098.jpg DSC00099.jpg DSC00100.jpg DSC00101.jpg DSC00102.jpg

03-10-2012, 05:03 PM	#11
Buggy I've been Wankeled! Join Date: Apr 2010 Location: Mildmay, Ontario, Canada Posts: 260 Rep Power: 16	I got the front suspension and brakes all assembled the other night and got the car back down on its wheels. My fear that it was going to be too low was then confirmed. It looks mean, but unfortunately I think it is going to have rubbing issues with the fenders when turning. I may have to make spacer plates to go between the camber plates and the strut towers to raise the front end back up a bit. I also stripped down the whole rear axle to get it ready to swap in and took measurements off of the rear axle to give to the guy that is building the leaf springs. Picture time! DSC00098.jpg DSC00099.jpg DSC00100.jpg DSC00101.jpg DSC00102.jpg __________________ 1976 Rx-4 hardtop. Half bridge 3B 13B, S5 NA rotors, Renesis e-shaft, stat gears, and bearings, balanced rotating assembly, RE dual weber 36 DCD's 203rwhp 137ft-lbs torque DGRR 2011 3rd place 1974 Rx-4 all original 27,000 miles 1988 Rx-7 TII 320rwhp. DGRR 2012 3rd place Last edited by Buggy; 03-10-2012 at 05:07 PM.