|
|||||||
| Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
|
Thread Tools | Display Modes |
|
|
#9 | |
|
Don Mega
Join Date: Dec 2008
Location: Utopia
Posts: 1,688
Rep Power: 18 ![]() |
Quote:
But at absolute MINIMUM I would like to see some kind of velocity trace, YES. If its based off wheel speeds then you are always going off a wrong trace then overlaid on top of that is the honesty of the calibration to make the speed reading right + the wheel slip factor added on top. To measure velocity CORRECTLY to determine honest speed you really need a GPS signal, top shelf stuff is around 100Hz Ghetto like Motec is around 5Hz lol, either way its 1 million times better than a wheel speed trace ![]() Consider your self edumecated LOL ![]() p.s. To validate ANY claims of speed to distance I also want to see the hieght and slope of where you run, again any decent GPS instrument will allow this, most ECU hack boxes will not , run down hill = much much faster , most people cheat themselves LOL
__________________
www.riceracing.com.au Worlds best Apex Seals Coil on Plug Water Injection ECU Calibration |
|
|
|
|
| Bookmarks |
|
|