Engine, tranny, turbo installed and exhaust started

[Seanrot]

Originally Posted by WE3RX7

What have you done for the carb and how much boost do you plan to run on it?

I actually have the 13BT IDA manifold and top hat which I acquired years ago while doing an ITB setup and have been thinking about throwing some 48IDAs on it and dropping the setup into a first gen with a stock turbo but I'm still a bit unclear on webers since my carb experience is limited.

Carb hat, polyurethane float, mill out one of the walls inside the carb for more fuel capacity. 300 or better needle valve, new gaskets and drill in three spots for fuel flow and drivability.
I ran 8lbs normal, 10lbs racing on my last setup and plan the same for
This one.