|
|||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
|
|
Thread Tools
|
Display Modes
|
|
|||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
|
|
Thread Tools
|
Display Modes
|
|
|
03-04-2013, 03:16 AM
|
#1 |
|
Clean S4 Nutswinger
Join Date: Mar 2008
Location: Sterling Heights, MI
Posts: 485
Rep Power: 18  |
Is this normal and/or acceptable? (rear hub bearing surface)
I just pressed out the rear hub and bearing, and noticed that part of the machined bearing surface of the hub has a texture (pictured below). The Area that is covered by the bearing race is smooth.
Is this normal? Is it caused by wear or is it just made that way? Is it okay to reuse? 
__________________
-Ted -1986 Mazda RX7 Sport [DD/beater]: engine finally let go at 205k. parts car status. -1986 Mazda RX7 base [resto-mod project]: S5 n/a swap in progress. 
Last edited by need RX7; 03-04-2013 at 03:32 AM. |
|
|
| Bookmarks |
|
|
Threaded Mode