Possible Weber float height problem...?

sen2two · 08-24-2014, 08:25 PM

I rebuilt and turbo prepped my 51 IDA Weber and attempted to start it. It did not feed any fuel. I am assuming at this point that it is my float setting.

Here's my current tune on my street ported 12a:

*Will eventually go blow through turbo

37mm chokes
3.2 Glass ball needle valve
60f10 idle jet
120 idle holder
195 main
150 air corrector
f-3 turbo e-tube

My question is, can I set my float height without removing the Weber? The way I set the height before involved hanging it upside down.

08-24-2014, 08:25 PM	#1
sen2two KTEC Join Date: Jan 2009 Posts: 642 Rep Power: 0	Possible Weber float height problem...? I rebuilt and turbo prepped my 51 IDA Weber and attempted to start it. It did not feed any fuel. I am assuming at this point that it is my float setting. Here's my current tune on my street ported 12a: Will eventually go blow through turbo 37mm chokes 3.2 Glass ball needle valve 60f10 idle jet 120 idle holder 195 main 150 air corrector f-3 turbo e-tube My question is, can I set my float height without removing the Weber? The way I set the height before involved hanging it upside down. __________________ what I have:* 1985 Gs:12a All motor Drag car - 1973 Rx2: Play car What I had: 93 Touring: TRADED - 91 Coupe: TRADED - 90 GTU: RHD - 88 10AE: SOLD - 87 Base: SOLD - 86 Base: SOLD - 1985 GSLSE - 85 Gsl: SOLD - 80 Gs: TRADED - 1972 Rx2