|
Rotary Tech - General Rotary Engine related tech section.. Tech section for general Rotary Engine... This includes, building 12As, 13Bs, 20Bs, Renesis, etc... |
|
Thread Tools | Display Modes |
![]() |
#1 |
Rally Fanboy
Join Date: Feb 2008
Location: New York
Posts: 147
Rep Power: 18 ![]() |
Bridge Port / Coolant Seal Question
No Limit Industries is helping me get a half bridge motor running. It was built by a reputable shop, and has like 100 miles on it. The motor is installed in the car now, and we were about to install the intake manifold/carb setup. One of the guys stuck his finger into the intake ports and felt something out of place.
It looks like there's a little piece of gasket material hanging into the intake port. When we felt inside the other ports, they also had some material. I assume it is one of the water seals, that no longer has a place to seat because of the porting. I don't want to rip it out for fear that the whole seal will come with it. I don't want to leave it because it seems like an obstruction to flow. I don't know enough about the porting procedures to know if this is bad or not. Any tips/advice/information would be greatly appreciate it. I'll call the builder this afternoon to get his opinion on it. ![]() ![]()
__________________
![]() |
![]() |
![]() |
Bookmarks |
|
|